This ring bending tool is used to bend flat shank into circular ring to match your finger ring size.

Simple and easy to use. Place ring grooves of stretcher, insert the mandrel, and drive it in until desired size is obtained. Mandrel is removed by tapping opposite end. Steps are 6.4mm" wide. For ring sizes 6 and larger. Complete with wood base.

Stretches rings with mountings when other stretchers cannot be used. Supplied with 17 rollers in wood storage box to accommodate all ring sizes. Easy to use. Replacement roller set also available. 4 lbs.

Easily Enlarge and reduce rings. Polished steel expanding mandrel has 6 segments and accommodates rings from 3 to 15. Reducing die with 16 countersunk, carefully formed and finished holes permit a wide variety of reductions. Will not scratch or mar rings. Overall height is 17" and four holes are provided in the base for securing it to a work bench.
Made in Ukraine.

Bend prongs away from stones easily, without putting pressure on the stone. This tool has numerous lifter notches to accommodate almost any faceted stone-removal situation.

This tool is for setting stone into " tube setting "

Stone setting system with hardwood handle and 18 concave tempered punches is ideal for setting stones. Simply insert the stone and press the punch directly over the prongs to set. The concave shape pushes prongs in gently and evenly. This system is especially good for more fragile stones. Supplied in an attractive wood box, it will set stones from 2mm up to 6mm in diameter.

From the mind of metalsmith and instructor Jay Whaley. The Rivette Sliding Hammer features a slender, hollow hammer head that holds a long punch that slides back and forth in the head. Jewelers typically use a hammer and punches to move metal, but that really isn't the "best" way to do it. There should be a better way, and this is what the Rivette does.
In bezel setting, the bezel needs to be hammer against the stone without damaging the stone. Channel setting requires moving metal to hold stones in place without breaking them. Chasing and repousse are done with repeated hammer blows. Even riveting needs careful accurate hammer blows for the right finish.
Since the punch slides within the hammer head, it is always perfectly aligned with the hammer blows. The impact the hammer blows can be easily felt by your hand so that you can quickly adjust your force.
The punch can rotate within the hammer body and the hammer head itself pivots. You can hold use the punch in whatever position is comfortable.
The hammer has a sculpted rosewood handle that is long enough to give maximum force. The punches are machined out of stainless steel for long life.
The Rivette comes with 3 punches that can be changed quickly and easily by just removing the machine screw on the hammer head. Each punch has pin that keeps it from falling out of the head.